How to Use:
Your Pump should come with a small initial charge. If it does not have a charge, charge it using the instructions in the charging section below.
The Pump is controlled by three buttons (figure 1):
• The power button for turning ON/OFF and switching between modes.
• The plus (+) button for increasing pressure level.
• The minus (-) button for decreasing pressure level and air release.
Before Use:
For optimal performance, ensure your pubic hair is clean and well-trimmed for a good seal. A warm bath or shower is recommended prior to relax the scrotum area away from the base of the penis. Only apply the minimal amount of vacuum pressure needed to achieve an erection. Do not use for more that 10 minutes within a 72-hour period.
ON/OFF:
To turn on, press the power button once. The LED screen will light up and stay lit when the Pump is on.
To turn off, press and hold the power button for 2 seconds.
Modes:
The Pump has 2 modes of operation to choose from: Automatic Mode and Manual Mode.
To switch between modes, repeatedly press the power button (figure 2). Show mode symbols
Automatic Mode:
In this mode, the Pump will go through an automatic pumping process which includes 3 pressure patterns followed by a final 30 second hold and air release.
This mode allows you to sit back and let the pump do the work for you.
*To stop the pressure/activate the air release at anytime, press and hold the minus (-) button.
To begin the process, press the plus (+) button once. To restart the entire process from the beginning, press the plus (+) button again at anytime.
Manual Mode:
In this mode, you can choose the desired pressure level (high, low, medium).
To increase the pressure level, continuously press the plus (+) button.
To return to the previous pressure level, press the minus (-) button.
Auto Off:
If the product is left in standby mode without use for more than 20 seconds, it will automatically turn off to preserve battery life.
Cleaning:
It is important to clean your product with toy cleaner before and after every use. Disassemble the controller, cylinder and sleeve. Wash cylinder and sleeve with warm, clean soapy water and rinse thoroughly. Let air dry before reassembling. To clean controller, simply spray or pump the cleaner onto a cloth and wipe away the cleaner. Leave to air dry.
Note: The removeable top of the pump is not waterproof. Do not submerge in water.
Always unplug before cleaning and allow to completely dry before use. Do not use any type of solvents such as alcohol or benzene, which may damage not only the finish, but the product itself. To avoid shock, keep the USB cord free from tangling and inspect it for damage frequently.
Charging:
Insert the pin of the USB cord into the charge port located on the front of the Pump (figure 3), and then plug the USB cord into a USB wall adaptor. The LED light will glow indicating that the unit is charging. When the unit is fully charged, the light will disappear.
If the product will not be used for long periods of time, the battery should be recharged at least once every three months. If possible, avoid fully draining the battery. Charge often between uses to prolong battery life. Only charge with the USB cord provided.
Health and Safety Precautions:
Discontinue use of pump immediately if any severe pain or discomfort occurs.
Consult physician if you experience any complications.
The use of a vacuum pump may bruise or rupture the blood vessels within the penis or scrotum, resulting in hemorrhage, or the formation of a hematoma.
Misuse of a pump may aggravate a pre-existing medical condition, resulting in swelling or bruising and/or permanent injury to the penis.
Do not fall asleep while using the device.
Do not use under the influence of alcohol or drugs as it may impair your judgement, increasing the risk of injury.
Do not use the pump more than 10 minutes within a 72-hour period.
Do not charge near water.
Do not charge if the USB cord appears damaged.
Do not use other USB cords with your product if the one provided is misplaced.
Do not drop on the floor, it will damage your product.
Do not put the product in the dishwasher or microwave, it will damage your product.
This product is sold as a novelty only. It is not intended for medical applications or any use that has an adverse effect on any function of the body.
Use a toy cleaner for all your cleaning needs, before and after use.
To avoid injury or aggravation of pre-existing physical conditions, this device should not be used on swollen or inflamed areas of the skin. Wash before and after use. Do not share with other sexual partners. Help to prevent other sexual diseases through the use of condoms, sexual education, proper judgement and rigorous, diligent care.
Never let children play with this product.
Storage:
Avoid extreme heat.
When not in use, store this product in a cool, dry place away from the reach of children.
Specifications:
All LUX Active products are tested for material and electrical safety and are RoHS Compliant and CE Certified.
Battery:
Run Time: Up to 4 hours
Output: 3.7V
Weight: 329g (not including USB cord)
Composition: ABS (Pump), Silicone (Sleeve)
Charging Time: Approximately 3 hours